Place the protractor on top of the timber and align the protractor's baseline with the edge of the timber. Use a protractor to lay out angle cuts for turns in your edging that are not 90 degrees. Repeat the same process at the other end of the straight row. Join the cut piece to the end of the row with mending plates, as before. When you reach one end of the edging run, mark the last piece for cutting at the desired length. Cut the marked timber to length, using a miter saw, if you have one otherwise, you can use a hand saw or a reciprocating saw.
If the screws are difficult to drive, drill pilot holes before installing the screws. Drive the screws with a drill fitted with a screwdriver bit. Join neighboring timbers with pairs of galvanized mending plates and 2-inch deck screws. Position the full-length timbers accurately along the edging line. If the final straight piece will be shorter than about 2 feet, shift the entire row of timbers so that the two ends will have cut pieces of roughly equal length. Lay out straight timbers along the full length of the edging, butting their ends together. These materials are much tougher than plastic and let water and air pass through, allowing the soil to breathe. If you want your landscape fabric to last (and to suppress weeds effectively), choose a commercial-grade spun fabric. The Spruce Home Improvement Review Board.
0 kommentar(er)
